6 devices irq11/temps?normal

[automaton]

:argue
TITIAN
skyhawk psr
front 48cfm /rear60mm@30cfm/80mm@42cfm

Epox i875p
fortron pfc400 psu


3.0ghz@3.03 /804 fsb
ocz el ddr400 platinum @404
2x plus9 8mb raid0

hi
ive gone from 3 gens of athlon to p4

my new mobo an epox 4pca3+ is running stable at the incredible
microverclock of 201

i have an irq question
im using win98se micro and have 6 devices on irq 11
http://www.litepc.com/98micro.html

3 i think i remember raid agp pci ide

i also have this temp question
im using alumina paste with spark 7+ at full speed
my temp from cold room cold boot is 42 ?
after 2 hours in photoshop its 50-52?
is that o.k.

should i
leave well enough alone ?
contact epox tech ?
the boards bios allows for manual assignment
?
i wonder if temp sensor is screwy

:argue

[Ioman]

I would leave things alone personally. If its stable, there is no reason to do anything else to it.

[ECA]

If those IRQ's are from windows, WHO CARES. Windows makes its own config.
As per temp, is this F or C...If F its fine. If C, you got one HOT room. So I will think F.... Anything 120 or less in F, is fine.
sence the temp change is only 10-12 degrees...Im hoping you take these temps from the Bios and not under windows, its fine.

If its stable, leave it alone. First sign you will get is auto shutdown from over heat.