ECA
01-19-2005, 06:21 PM
http://www.michna.com/kb/WxDMA.htm
DMA is an abbreviation for Direct Memory Access, an access method for external devices where the data transfer is not done by the central processor, but by a small special processor called DMA controller. It uses a procedure called cycle stealing, where the central processor memory access cycles are delayed for very short times to intersperse DMA controller memory access cycles. Some newer, faster DMA modes are called UDMA (Ultra DMA).
PIO mode is enabled by default in the following situations:
...
For repeated DMA errors. Windows XP will turn off DMA mode for a device after encountering certain errors during data transfer operations. If more that six DMA transfer timeouts occur, Windows will turn off DMA and use only PIO mode on that device.
In this case, the user cannot turn on DMA for this device. The only option for the user who wants to enable DMA mode is to uninstall and reinstall the device.
Windows XP downgrades the Ultra DMA transfer mode after receiving more than six CRC errors. Whenever possible, the operating system will step down one UDMA mode at a time (from UDMA mode 4 to UDMA mode 3, and so on).
...
Of course, drive firmware being quite complex and certainly containing programming defects of its own, it is not all that difficult to produce such errors. In my case a scratched DVD and later also an unreadable (overburned) CD did the trick, got the drive to choke and Windows to disable DMA for good. Later my hard disk hiccupped just once and also went back to PIO for good.
DMA is an abbreviation for Direct Memory Access, an access method for external devices where the data transfer is not done by the central processor, but by a small special processor called DMA controller. It uses a procedure called cycle stealing, where the central processor memory access cycles are delayed for very short times to intersperse DMA controller memory access cycles. Some newer, faster DMA modes are called UDMA (Ultra DMA).
PIO mode is enabled by default in the following situations:
...
For repeated DMA errors. Windows XP will turn off DMA mode for a device after encountering certain errors during data transfer operations. If more that six DMA transfer timeouts occur, Windows will turn off DMA and use only PIO mode on that device.
In this case, the user cannot turn on DMA for this device. The only option for the user who wants to enable DMA mode is to uninstall and reinstall the device.
Windows XP downgrades the Ultra DMA transfer mode after receiving more than six CRC errors. Whenever possible, the operating system will step down one UDMA mode at a time (from UDMA mode 4 to UDMA mode 3, and so on).
...
Of course, drive firmware being quite complex and certainly containing programming defects of its own, it is not all that difficult to produce such errors. In my case a scratched DVD and later also an unreadable (overburned) CD did the trick, got the drive to choke and Windows to disable DMA for good. Later my hard disk hiccupped just once and also went back to PIO for good.